ANA-06    
 
Our Products
  Basic Electronics Trainers
  Analog Electronics Trainers
  Digital Electronics Trainers
  Power Electronics Trainers
  Operational Amplifier Op-Amp   Trainers
  Network Analysis Trainers
  Load Trolley
  Excitation Control Systems
  Torque Motor Controller
  Power Supplies AC / DC
  Digital Meters
  Transformers: CT/PT
  Decade Resistor Box
  Other Products
   
CLASS-B PUSH PULL AMPLIFIER USING BJT
     
    SPECIFICATION :
 
  • Box Size : 250 x 200 x 50 mm
  • Input Power Supply : 1 Phase, 230Vac, 50Hz AC Mains
  •  
  • Built in IC regulated DC Power supply : +12Vdc
  • In Class-B Push Pull amplifier using two Transistors and operating point fixed near to
  • cutoff region.
  • Conduction of each transistor is approximately 1800 Extra Instruments required are as : CRO Sinusoidal Signal Generator
  •   OBJECTIVE :  
     
  • Observe and draw the input and output voltage waveforms.
  • Calculate the voltage gain of amplifier. Plot the frequency response.
  • Measure the output AC power delivered to the load and measure the DC input to the amplifier calculate the efficiency of Class B amplifier
  •      
     
     
                Copyright received by : satyaedutronics     |    Design by : Marutimediasolution.com